NF868 Phone Network Circuit Cable Wire Line Finder Tracker Tester

NF868 Phone Network Circuit Cable Wire Line Finder Tracker Tester

NF868 Main function characteristics:
 
1. Capable to test open circuit, short circuit, cross connection, reverse connection and pairing connection and broken wire positioning for telephone cable, BNC cable and USB cable with M-S and M-R method, and to visually display on LCD;
2. To perform crosstalk test on network cable for solving the potential problem of slow speed;
3. To quickly find the target wire or cable among the plenty of network cables, telephone cables, coaxial lines and other various kinds of wires;
4. To make a accurate determination of open circuit position (left, right or middle);
5. To perform cable tacking on exchanger or Router with power-on;
6. Capable to measure length of network cable, coaxial cable, telephone cable and USB cable with three method (M-S, M-R and OPEN), capable to measure the cable at length of 1500m, and precision of measuring cable length and position of broken line is up to 98%;
7. Self-test function shall automatically make compensation due to change of battery level and ambient temperature;
8. Low voltage prompt function is available in case of over low voltage on the main unit;
9. Featuring simple control, large screen display and open-and-shut test result;
10. Automatic delay power on-off and backlight function;
11. Lighting lamp enables to use in a dark environment;
12. Single chip software watchdog design runs reliably.
 
NF868 Technical parameters:

1. Overall dimensions

Main tester: 185X80X32mm
Receiver: 218X46X29mm
Remote identifier: 107X30X24mm

2. Display

Dot matrix 128X64 (Effective visible area 56X40mm)

3. Power supply

Main tester: 9V compound tandem cell; (not include)
receiver: 9V compound tandem cell; (not include)

4. Testing cable types

STP/UTP 5E, 6E network cable, telephone cable, coaxial cable USB
signal cable and common metal wires connected with alligator clip

5. Detecting cable types

STP/UTP 5E, 6E network cable, telephone cable, coaxial cable USB
signal cable and common metal wires connected with alligator clip

6. Operating environment temperature/humidity

-10℃~ +60℃/20% ~ 70%

7. Testing device interface

Main unit: RJ45 (M), RJ45 (S), loop interface, RJ11, BNC connector
USB B-type female interface
 
Remote identifier: RJ45, RJ11, BNC connector, USB A-type female interface

8. Length measurement

Range: 1-1200m
Calibration precision: 2% (+/-0.5m, or +/-1.5 feet); (calibration; cable >10m) measurement precision: 3% ((+/-0.5m, or +/-1.5 feet)
(AMP, CAT5E, 6E cable material)
Display unit: meter, inch, yard

9. Length calibration

User may use a cable at a known length to set a calibration coefficient, and the calibration length is over 10m

10. Line sequence and cable failure positioning

Used for Line finding two-core cable or cable with over two cores

11. Line finding function

Used for Line finding two-core cable or cable with over two cores

12. Automatic delay of power on/off

It will automatically power off in case of no operation within 15 minutes

 

Package including:
 

1 x Tester

1 x Receiver 

1 x Distal recognizer

1 x User manual 

1 x Earphone

3 x Cable

1 x Tool bag